How to Apply the Orlandoo-Hunter Crawler Decal Package

Quick Answer

Apply the Orlandoo-Hunter Crawler decal package by cleaning the surface, cutting decals individually, soaking in warm water, sliding onto the model, and pressing out bubbles with a soft cloth.

Step-by-Step Decal Application

1. Prepare the Surface: Clean the model body with mild soap and water to remove dust and oils. Dry thoroughly with a lint-free cloth. A clean surface prevents decals from lifting later. Check that the surface is completely dry before starting.
2. Cut Out Each Decal: Use sharp scissors or a hobby knife to cut close to the decal edge. Leave a small margin of clear film to avoid cutting the printed design. Cutting too close can cause the decal to tear. Cut one decal at a time to avoid confusion.
3. Soak the Decal: Dip the decal in room-temperature water for 10–15 seconds until it slides freely on its backing paper. Do not oversoak—this can weaken the adhesive and cause the decal to curl. Test a small corner to see if the decal moves before removing from water.
4. Position the Decal: Slide the decal onto the model using a wet finger or tweezers. Align it with panel lines or reference marks. Once placed, gently press from the center outward to expel air bubbles. Work slowly; you have about 30 seconds before the decal starts to set.
5. Blot and Seal: Use a soft cloth or cotton swab to blot excess water and press the decal firmly. For a sealed finish, apply a thin coat of decal setting solution or clear gloss varnish after 24 hours. Avoid rubbing the decal once it starts to dry—it may lift or tear.

What You Need

• Orlandoo-Hunter 4WD "Crawler Pickup Truck" Appearance Package: Includes a Splash Orange water sticker decal sheet and 4 metal wheels with disc brakes. The water-slide decals allow repositioning during application, reducing the chance of misalignment.