Disco divisor

The engraved degree markings are crisp and easy to read, which made dialing in 15-degree increments for a hex nut a breeze. Bolted right onto my rotary table with zero fuss and held position solidly through the whole cut.

Machined a 24-tooth gear blank this weekend and every single division came out dead on, not even a thou of drift. The bolt pattern for mounting it to the rotary table lines up perfectly with the existing holes. This thing turned a fiddly setup into a one-and-done job.

I was really nervous about spacing teeth evenly on a gear, but this dividing plate made it so straightforward—just dial in the degrees and go. The fit on my rotary table was perfect, and it saved me from hours of guesswork.