Infini 模型面板劃線筆 (0.15mm)

I was a bit worried about the 0.15mm tip being too fragile, but it’s actually held up well scribing new panel lines on a 1/72 tank. The tungsten steel cuts cleanly without chipping the plastic, and the grip is comfortable for precise work.

The tungsten steel tip cuts through plastic like butter, making clean 0.15mm lines without any chipping. I used it to add extra detail to a car model and the depth is perfectly consistent.

I’ve used it to re-scribe a few panel lines on a kit that had worn down, and the tungsten steel tip cuts cleanly without chattering. The 0.15mm point is fine enough for 1/144 scale work, and it’s held up well so far.